Narco AT150 TSO Transponder 1976 Maintenance Manual. Narco AT150 TSO Transponder 1976 Maintenance Manual. Customer Service. Browse and Read Narco At150 Manual Narco At150 Manual Give us 5 minutes and we will show you the best book to read today. This is it, the narco at150 manual that will be. Narco AT-150 Transponder. Home >Manuals >Narco AT-150 Transponder >Electrical Installation: 2.5 Electrical Installation 2.5.1 Power And Interconnect Cable.

Narco AT 150 - Electrical Installation Narco AT-150 Transponder Electrical Installation >>>Electrical Installation 2.5 Electrical Installation 2.5.1 Power And Interconnect Cable The Installation Kit provides an 18 pin Molex connector along with sufficient pins for fabrication of the power and interconnect cable. Figure 2-4 presents the electrical connections and Figure 2-5 presents a system orientation diagram. All signal leads should be 22 AWG. A+ and ground leads should be 16 AWG. The ground lead should be connected directly to airframe ground. A 1.5 amp circuit breaker should be provided between the unit and the aircraft power bus.

Figure 2-4 - Power and Interconnect Cable Figure 2-5 - Orientation Diagram 1. Transponder 7. Panel Lamp Dimmer 2.

Mounting tray with Antenna Cable Assy 8. Altitude Digitizer Cable 3. Power Connector 9.

Altitude Digitizer 4. Antenna Cable Extension 10.

External Suppression (+) 5. External Suppression (-) 6. Power Supply Bus and Circuit Breaker 12. Remote IDENT 2.5. Steel Armor Blaze Of War Demo here. 2 Cable Fabrication • Strip wire 5/32' for PIN Terminal No.

• Open tool (engraved side toward you), from the opposite side, place the conductor tab section of the pin on Anvil B. Close tool slightly (until the tabs touch the female jaw). • Insert stripped conductor until insulation is level with outside of jaw. Crimp by squeezing handles together until jaws are fully closed or sufficient crimp is made.

• Move lead and pin to Anvil A. Crimp again until jaws are closed or sufficient crimp is made. • If necessary, straighten pin while still being held in the jaw. Figure 2-6 - Crimping Tool Insertion • The PIN terminal may now be inserted into the desired pin location in the translucent connector housing.