From Georgia was able to fix his Bolens walk-behind lawn mower, by replace its inline fuel filter. Locate the filter by following the fuel line from the tank. Once you have access to the filter, you can either use fuel line clamps, or drain the gas from the mower prior to removal to avoid any spills. Once this is done, remove the fuel line clips hold the filter with a pair of pliers, and then remove the filter itself from the lines.

To reinstall, simply press the filter onto the lines and reinstall the clamps. After it had been running poorly for some time, Tyler F. From Idaho got his Bolen’s log splitter running properly again by replacing his spark arrestor screen. To replace or clean the spark arrestor, remove the screws on the muffler cover, and pull the cover off. Then remove the spark arrestor assembly itself from the muffler.

Disconnect the screen from the assembly. Place the new screen on the arrestor assembly and reattached it to the muffler, then reattached the muffler to the engine. From Washington was able to get her Bolen tiller running properly again by replacing its carburetor.

Nishiki Serial. To replace the carburetor, first take off the air filter cover and take out the filter. Then remove the nuts holding the base of the filter housing.

The Bolens Gas Trimmer is lightweight and has a wide 17-inch cutting swath. Read more at Top Ten Reviews. The Bolens Gas Trimmer is lightweight and has a wide 17-inch cutting swath. Read more at Top Ten Reviews. Find great deals on eBay for bolens string trimmer. Shop with confidence. Repair Parts Home Lawn Equipment Parts MTD Parts MTD Trimmer Parts Bolens BL110 (41AD110G965) Trimmer Parts. Do you have a carb kit for the Bolens string trimmer?

Then detach the primer line and crank case vent line, by loosening their clips. Remove the fuel line (once all gas is drained or a fuel line clamp is in place. You can now pull the carburetor and gaskets away from the engine. Finally, disconnect the throttle linkage.

The Warriors For Pc Iso Game here. To install the new carburetor, reattached the throttle linkage, slide the carburetor back over the mount bolts. Reinstall the gaskets and fuel line. Reconnect the primer and crank case vent, then reattached your air box base, filter and cover.

Measure about 20 feet of new trimming line and loop it into two equal lengths. Insert each end through one of the two holes in the inner reel.

Pull the trimmer line through the inner reel so the loop is as small and tight as possible. Wind the lines in even layers onto the reel in the direction of the arrows on the inner reel. To make sure the two lines do not overlap and tangle later while you are using the trimmer, place your index finger between the two lines to keep them apart.

Spss Spv File Reader. Insert the ends of the line into the two holding slots.